ON FPF2701MX

Общее назначение1Не требуется2A

Overview

The FPF2701MX is an AccuPower™ adjustable over-current protection Load Switch for hard disk drives. The AccuPower™ FPF270X series is a family of current-limit load switch that provide full protection to systems and loads from excess current conditions. Minimum current limit is adjustable from 0.4 to 2.0A. The FPF270X contains a slew-rate-controlled N-channel MOSFET and slew-rated turn-on to prevent power bus disturbances from being caused by hot plugging loads or momentary excess load demands. The input voltage range is 2.8 to 36V. Loads can be activated or deactivated with a low-voltage logic-compatible on pin. Fault conditions can be monitored using the error flag pin and/or the power-good pin. Each member of the FPF270X family serves a category of load-fault response. All devices clamp the load current so that it cannot exceed an externally programmed current level. An over-temperature feature provides further device protection in case of excessive levels of power dissipation.

Features

AccuPower™ Series
Tape & Reel (TR) Package
General Purpose Switch Type
1 Number of Outputs
1:1 Ratio - Input:Output
High Side Output Configuration
On/Off Interface
2.8V ~ 36V Voltage - Load
Not Required Voltage - Supply (Vcc/Vdd)
2A Current - Output (Max)
88mOhm Rds On (Typ)
Inverting Input Type
Power Good, Slew Rate Controlled, Status Flag Features
Current Limiting (Adjustable), Over Temperature, UVLO Fault Protection
Surface Mount Mounting Type